The Intex Deluxe Pool Maintenance Kit also includes a vacuum that sucks debris off the pool floor and through the filter and can attach to the outlet connector in the pool with a hose.

This set also includes a telescopic aluminum shaft for use with 18 feet diameter pools and above.

The telescoping aluminum shaft can be used with the following included attachments:
- Vacuum head.
- Durable and deep mesh skimmer net.
- Wall brush attachment.

1. The filter pump is an airtight system. To eliminate air trapped in the hose or in the pump, turn the air release valve (if any) 1-2 turns in a counter-clockwise motion to open the valve. Refer to the pump owner’s manual for details.

2. When water starts flowing out of the air release valve hole, screw in the air release valve back into the filter housing cover. Do not over tighten the valve.

3. Connect the filter pump to the power outlet and turn ON the pump.

4. In soft gentle strokes "sweep" the entire bottom surface of the pool liner until it’s clear of debris.

5. Make sure the filter pump is turned off, and disconnect the power cord from the electrical outlet. Remove the pool vacuum from the pool.

6. Using the Set-Up instructions in reverse, disassemble the vacuum cleaner. Clean the debris bag if necessary.

7. Store the pool vacuum in an area where it will not be a safety hazard.