https://padlet.com/josephfrempong98/r5oue3mm8x3x en-us 2017-01-13 09:25:25 UTC 2017-01-13 10:23:50 UTC hello@padlet.com josephfrempong98 https://padlet.com/josephfrempong98/r5oue3mm8x3x/wish/146986876
to start off you will need to prep the wall by giving 1 coat of pva to control the suction once pva has dried you will put your first screed up around 600ml wide and 10ml thick on one side of the wall and rule it off with a straight edge and spirit level to make plumb using level then your next screed on the oppersite end of the wall to where you applied your first around the same size and again rule off the make plumb. the next screed will come across the high middle meeting the top of each side screed once applied rule off till plumb with the others the final screed will come along the botttom and again be ruled off plumb with the other screeds. now you will have two halfs of the wall to fill you will start with filling in the bottom half of the wall then ruling it off plumb with all screeds. finally you will fill the top screed and rue off to flat and plumb all over once firmed up you will need a devil float to scratch wall to provide key for next stage. in one coat work the same method will be applied but without the devil float instead you will use a finishing trowel with sponge float ,so once all filled you will trowel it then sponge around 3 times each until wall is smooth and plumb all over.]]> 2017-01-13 09:28:04 UTC https://padlet.com/josephfrempong98/r5oue3mm8x3x/wish/146986876