by Elias G Pena

step:3

epena3 — 2015-12-17 02:52:05 UTC

My next step was to flatten out the ring so i can make a good bend for the ring.

epena3 — 2015-12-17 02:53:29 UTC

The next step to the this process was to hammer the ring to a certain fit.

epena3 — 2015-12-17 14:45:45 UTC

Next I used and filers to file it down so it can be smoother than it was.

epena3 — 2015-12-17 14:46:08 UTC

In this picture i cut off soder pieces and burn them on to the ring to add a double layer so i can make my ring thicker.

epena3 — 2015-12-17 14:51:30 UTC

I bent it by using two pliers and I bent it intill it got to wear i wanted it to be and.

epena3 — 2015-12-17 15:20:36 UTC

FIrst I found my project design.

epena3 — 2015-12-17 15:35:51 UTC

Then I started to sand it so It can be more cleaned up.

epena3 — 2015-12-17 18:25:12 UTC

Finished