How I created the style: 

Make curls for movement. Movement in the hair make it easier to roll the hair rolls. After the hair curls, section at the top of the hair becomes 3. The section at the front is for making bumper bang. For the bumper bang I use back comb to tease the hair roots. I smooth out the hair bringing the hair together as one section then roll the hair till it sits straight across the forehead. I Pin the hair to help keep the bang secure. I make victory rolls by backcombing then smoothing with the brush (placement back comb technique). I wrap the hair around my finger then roll it and pin it. Repeat on the other side to make the other roll. I add a few discreet pins for grip. I add hair rat and a couple of pin curls on the top at the back of the hair. Finished off with hair spray and pin few red flower 🌺

What went well? I found victory rolls hairstyle quite practical/manageable yet the look is feminine and beautiful. Did anything not go so well? To incorporate this style with another hair style without loosing the essence of the look as I have not discovered a lot of hair styles yet.How you adapt to overcome next time? practice more with this incorporated hairstyle in the future. 11-05-2020.

I have one length cut doll training head with fine hair (to add volume) so I perform a forward graduation hair cut for layering long hair and  with face frame layers. 

Section ear to ear. First, I put guide line on the top of hair, then pull up at 180 degree angle and hold the hair with tension between the fingers. I cut using the club cutting technique to reduce the length of the hair and then comb back into hair. I make an inch deep straight line on the back and pull up with tension between the fingers and then cut again. Continue to cut the hair. The section is like orange section. Cross check the opposite way.

Face frame layers with centre parting. 

I cut the hair with diagonal line then cutting parrarel from that line. Maintain high elevation for a nice graduation shape look on the front. I keep cutting the hair with 0 degree angle until you can see curve line on the front. I Continued  on the side until running out of hair and you have face frame. I take a little piece on the top of the hair for guidance line, this determines how long the hair should be cut. I take another hair on the opposite side and cut the hair exactly the same as the opposite side ( repeat on the motions of cut same like the other side). Maintain high elevation for a nice graduation shape look on the front. I cut inch By inch. Create kind of wrap around the face until the hair reaches the ear and also about to run out of hair. I checked both sides are even balanced.

Art of dressing:

To create little movement for body and root lift of hair, I use dry setting directional-wind technique using Velcro rollers. Then make backcoming hairstyle. Finished by spraying hair spray. Health & Safety was followed throughout the service.
17-05-2020.

02-06-2020.

Apply mouse/styling product. Section the hair into manageable sized sections. I part the sections clearly and evenly to achieve nice direction of the cornrows. I start plaiting the hair in cornrows for the top of the head until half the head, then tighten it up with small plastic band. I ensure the balance to achieve half head desired look.
For the back of the head I use a wand to create curls and movement: taking small clean sections then wrap hair around the wand and wind down from root to point. I continue to pin curls to create messy slides curls by roll the hair and pin it.

03-06-2020.