https://padlet.com/khymcm5171/kk8opf2sk8r1 en-us 2016-10-04 13:04:59 UTC 2025-10-19 19:26:00 UTC hello@padlet.com khymcm5171 https://padlet.com/khymcm5171/kk8opf2sk8r1/wish/128149369 2016-10-04 13:14:15 UTC https://padlet.com/khymcm5171/kk8opf2sk8r1/wish/128149369 khymcm5171 https://padlet.com/khymcm5171/kk8opf2sk8r1/wish/128149593 first you take a wooden block drill a 2 holes on the sides, take the copper wire and bend it into a little circle at the top put them in each hole take a wire and wrap it around until it forms a circle have 2 pieces left shave off the whole side on one side and half the side on the other then put it in the circle of the copper wire take a battery holder tie it tightly to the copper wire then take a battery and put it in the battery holder take 2 magnets and glue it on the middle of the block give the wire a push and then it will start to rotate ]]> 2016-10-04 13:14:47 UTC https://padlet.com/khymcm5171/kk8opf2sk8r1/wish/128149593 khymcm5171 https://padlet.com/khymcm5171/kk8opf2sk8r1/wish/128152666 the wire is the armature u had the sand it because the magnet would attract to the gravitation and make the wire spin the commutator is the copper wire and the battery which caused the motor to work ]]> 2016-10-04 13:21:14 UTC https://padlet.com/khymcm5171/kk8opf2sk8r1/wish/128152666 khymcm5171 https://padlet.com/khymcm5171/kk8opf2sk8r1/wish/128154364 it works by the battery and the energy connected to the wire and then connected to the copper wire which the magnet causes the armature to move ]]> 2016-10-04 13:24:41 UTC https://padlet.com/khymcm5171/kk8opf2sk8r1/wish/128154364