https://padlet.com/wonderfulideaco/CCGW1pins Please post photos and videos of your programmed pin creations en-us 2021-11-24 05:22:37 UTC 2025-10-23 09:05:14 UTC hello@padlet.com https://padlet.net/icons/png/2699.png wonderfulideaco https://padlet.com/wonderfulideaco/CCGW1pins/wish/1909892431 2021-11-24 05:33:23 UTC https://padlet.com/wonderfulideaco/CCGW1pins/wish/1909892431 wonderfulideaco https://padlet.com/wonderfulideaco/CCGW1pins/wish/1909892718 2021-11-24 05:33:40 UTC https://padlet.com/wonderfulideaco/CCGW1pins/wish/1909892718 wonderfulideaco https://padlet.com/wonderfulideaco/CCGW1pins/wish/1909893692 2021-11-24 05:34:43 UTC https://padlet.com/wonderfulideaco/CCGW1pins/wish/1909893692 https://padlet.com/wonderfulideaco/CCGW1pins/wish/1911114288 On BRB (big red button) press, countdown, and launch a blinking LED. Code here: https://makecode.microbit.org/_hpcWo6Y4A9gk]]> 2021-11-24 18:07:02 UTC https://padlet.com/wonderfulideaco/CCGW1pins/wish/1911114288 https://padlet.com/wonderfulideaco/CCGW1pins/wish/1918758055 Switch red LED light bulb with music. code: https://makecode.microbit.org/_KUp4Hp8KTg4p]]> 2021-11-29 19:04:39 UTC https://padlet.com/wonderfulideaco/CCGW1pins/wish/1918758055 https://padlet.com/wonderfulideaco/CCGW1pins/wish/1931736340 this uses the capacitive touch capabilities of the micro:bit logo and conductive tape. When I "long press" (touch the wire) the trigger hairs it sends a signal. I wanted to use the motor to close the flytrap but realized that I needed to rethink and simplify how I had these elements set up.]]> 2021-12-06 17:37:52 UTC https://padlet.com/wonderfulideaco/CCGW1pins/wish/1931736340