https://padlet.com/20whitepa/488z4r1hxwzx Made with a wish on a star en-us 2018-01-10 15:19:49 UTC 2023-05-18 13:56:06 UTC hello@padlet.com 20whitepa https://padlet.com/20whitepa/488z4r1hxwzx/wish/220205133 Article: line up the blade with one side of the mark. Fine tune the cuts. Back up small delicate pieces. Use stop blocks for repeat cuts.


Vidja: look over your wood. never cross your arms to hold the wood/saw. Push the button to start the saw. Then pull the trigger. Let the saw get up to speed and then cut your wood. Dont grab the wood until the saw is completely stopped. Unplug it when not in use or replacing blades.]]> 2018-01-10 15:22:07 UTC https://padlet.com/20whitepa/488z4r1hxwzx/wish/220205133 20whitepa https://padlet.com/20whitepa/488z4r1hxwzx/wish/220624314 1. So the nails go in the right way.
2. Your fastener should be twice as long as what you are gong through.
3. Perpindicular, less likely to blow out.
4. Keep hand away from where nail goes in.
5. Keep nails out of gun until ready to work.
1. saves work
2. less time 
3. accurate work
1. more expensive, dangerous sometimes.
3. Put glued nail strip into magazine. The nails are pushed into the barrel. The hammer falls and pushes the first nail into the wood.
4. They don´t have to be individually loaded.
5. By air.
6. dont point at others. dont load nails until ready. dont put hands near it.

]]> 2018-01-11 15:26:56 UTC https://padlet.com/20whitepa/488z4r1hxwzx/wish/220624314 20whitepa https://padlet.com/20whitepa/488z4r1hxwzx/wish/221007923 Band saw, jig saw, 
Saber saw
You cannot cut thick lumber.
Shoe
U shank and T shank blades
You could have a not square cut.
Drill a hole, put the blade in it and carve it out with the saw./]]> 2018-01-12 15:37:38 UTC https://padlet.com/20whitepa/488z4r1hxwzx/wish/221007923