# data[].attributes.body
The purpose of this project is to design a baby incubator to help preborn babies stay warm.

# data[].attributes.body
For this project we used PCMs that when a button was clicked the pcm heated up. We figured out that the PCM B plateau was very high and the PCM C plateau was very low so we evened them out.

# data[].attributes.body
We tryed to keep the babie's temperature as close to 37 degrees celceus as posible. Our design was 36.8 degrees.

# data[].attributes.body
We tryed to get the cost low so more people could have them to use. Our cost was $104.

# data[].attributes.body
Our time outside healthy range was a little to high it was at 64 and our goal was to have it at at least 60 minutes or lower.

# data[].attributes.body
The trade offs on our design were that the time outside of the zone was 64 min but the cost was high. The reason our cost was so high was because we used multiple layers of cotton so the baby would saty warm.