# data[].attributes.body
This is my lizard in its earlier stages. I had created the body from a long log of clay, and made the legs separately. I then attached them using the slip and score technique.

# data[].attributes.body
This is just a closeup of the previous picture.

# data[].attributes.body
This is a picture I took while contemplating where to position my lizard on the wall relief.

# data[].attributes.body
This is a picture I took after I hollowed out my lizard before attempting to attach it.

# data[].attributes.body
It's hard to see, but this picture shows the texturing I added to the top of the lizard using a design sample I borrowed from my mom.

# data[].attributes.body
This is the support structure on the back of my wall releif

# data[].attributes.body
This is just the other side of the background slab prior to adding the sand texture.

# data[].attributes.body
This was my final product. I had attached the lizard with his tail hanging off the side because I like the way it looked and it added some length to the sculpture.

# data[].attributes.body
The sand texture was added after the lizard was slipped and scored on, by adding a layer of slip and then covering it with hardened clay bits.

# data[].attributes.body
this is just the same thing from a different angle.