# data[].attributes.body
Please continue preparing Aim A Unit 24 use files , resources and lesson recordings  linked in Teams

# data[].attributes.body
Start preparation for Unit 6 by installing FlowCode8 - links will have been emailed to you directly. Familiarise yourself with a the software using this YouTube clip clip

# data[].attributes.attachment_link.title
Flowcode 8 Introduction with Eblocks EB083 (old Comboboard)

# data[].attributes.body
Following last weeks lessons you should all have installed TechSoft DesignTools V3 - see links in teams.

# data[].attributes.attachment_link.description
Share your videos with friends, family, and the world

# data[].attributes.body
Please note ALL Exams have been cancelled due to National Lockdown - we are awaiting further instructions from Exam Board

# data[].attributes.body
New Exam Papers and reports added for revision

# data[].attributes.body
Start analysis of all 3 graphs/tables produced in terms of production efficiency

np & p ; wastage/defects

X & R; variations in diameter - what can be done to improve deviance ?

Cpk and Cp - why is the median close to Lower control limit - could this pose a problem ?

# data[].attributes.body
Mechanical Measurement and Inspection Technology

# data[].attributes.body
Use these example slides to finish your Aim C; use the internet to select 2 processes and investigate / analyse them. The emphasis is on the environmental impact / recycling. Create a table as shown in the slides below (you do NOT have to do 4 parts/processes)

# data[].attributes.body
Exam practise ; 1st task planning
complete worksheet

# data[].attributes.body
Computer Aided Design in Engineering (all parts Aim A)

# data[].attributes.body
Unit 3 Vacumforming Research

# data[].attributes.body
CAD in Engineering (Distinction sample Aim A)

# data[].attributes.body
Create X & R charts fromTable 3

# data[].attributes.body
Use the research links to investigate Vacuum Forming
http://www.technologystudent.com/equip1/vacform1.htm

# data[].attributes.body
If Finished Aim B go o to Aim C

# data[].attributes.body
Unit 30 Aim B
Finalise Aim B to Specification

# data[].attributes.body
If finished with Aim B please prepare for Aim C see link to Powerpoint

# data[].attributes.body
Use the YouTube clip below to create a 3rd angle Orthographic Projection using 2DDesigntools;

Remember to use 5mmm Grid Lock & blue dotted lines for the projection lines (5mm pitch)

# data[].attributes.body
Students MUST compare 2 different materials used in the Fischer Price educational toy ; see slide example

# data[].attributes.headline
Please Visit our CTK Engineering Apprenticeship Channel

# data[].attributes.subject
Please Visit our CTK Engineering Apprenticeship Channel