# data[].attributes.body
the inside

# data[].attributes.body
bottom of the cup

# data[].attributes.body
this is a short cup i made this was supposed to be a mug but it was my mistake i didn't put enought effort to try and make a handle. i do remember how to do one when we get back im going to attempt it

# data[].attributes.body
this was removed from the rack you said it was sharp around the egdes so i did go back and fix it i just didn't get the chance to take a picture of it

# data[].attributes.body
this angle is more for the detail of the ring and the heart shape

# data[].attributes.body
inside of the double bubble, this def took me the longest because opening the clay and lifting the weight were the most worst parts I kept struggling.

# data[].attributes.body
my signature

# data[].attributes.body
front angle of double bubble

# data[].attributes.body
trimmed bottom angle of double bubble

# data[].attributes.body
when opening it i added too much water at the bottom the floor started to crack and the top was ready to flop

# data[].attributes.body
i think this was my best one thin but not too thin it comes at out at the top a bit to thick at the bottom

# data[].attributes.body
my fingers when opening had too much pressure so it opened wider rather than it coming up

# data[].attributes.body
same thickness on the side and the bottom was too thin

# data[].attributes.body
a bit thick from sides the bottom floor was too thin and the top came of