# data[].attributes.body
For the back of the ear I was not able to blend out the edges so I had to slip clay and smooth it out.

# data[].attributes.body
For this part of the ear I got my xacto knife to cut to the shape and then i pinched the edges and smoothed it out.

# data[].attributes.body
For the ear I grabbed some clay and molded it to the shape of the ear which is where i then began sculpting it to the what it looks like in the picture. Afterwards i then slipped in onto the mug and smoothed out the edges. The next piece the covered the ear was done the same way with clay and then slipped onto the mug and top and bottom of the ear.

# data[].attributes.body
As you can very clearly see the handle isn’t smoothed out the markings from the loop tool are visible but it was fixed the next day and I did not take pictures of it then.

# data[].attributes.body
For the ear handle i was going for trying to recreate the actual shape of the ear but with the inside cut out for the handle but it did not go too well so I ended up shaving it down to a good enough handle. What i planned on doin. was placing the clay and then sculpting it to the shape of the ear but i wasn’t able to so i just tried smoothening it to a decent handle because I was frustrated that the handle doesn’t match the rest of the mug. There also aren’t too many pictures since I was “in the zone”

# data[].attributes.body
The area caved in more than it should so i added clay to fix it.

# data[].attributes.body
Accidentally scrapped off too much clay so i had to slip and seal some clay to fix it.

# data[].attributes.body
This is where I was unable to fix it so i scraped off the eyes.

# data[].attributes.body
For the eyes and eyelids it was the same process except i did mess up and have to scrape off what i had to restart.

# data[].attributes.body
Same process for this I used a small wet paintbrush as well as the scraping tool because there was too much clay that i needed to bit by bit scrape off rather than start over.

# data[].attributes.body
Another error where i noticed on the reference picture something else to change about the mouth area. For this i just got a plastic card to separate and make the new piece and then smoothed it out with a small wet paintbrush.

# data[].attributes.body
Here is where i noticed the mouth area was off and realized the upper lip had extended volume to the cheeks.

# data[].attributes.body
Same process done for the upper lip but i also used a small wet paintbrush to blend edges in with the areas of the face that we have so far.

# data[].attributes.body
For the chin and everything else I did the same process of shaping a piece of clay then slipping and placing on the mug and then smoothening out. I also slowly scraped away some clay if there was too much clay. I also used a paint brush end to blend the clay edges.

# data[].attributes.body
For the cheeks i simply grabbed clay and shaped it close to what I would want it to be on the mug. Once I got to the shape i wanted i then slipped the mug and cheek clay and then placed it on the mug. I then made sure to seal off the edges and then smoothed out the edge to blend it in with the mug.

# data[].attributes.body
Each column will be in the order of what i did but there are a few times where i went back to add clay to some areas of the face.

# data[].attributes.body
The mug was done from the wheel. There is no picture of it plain.