# data[].attributes.body
Our model was a beam bridge and it had two supports holding up the beam.
Tests:
Penny stack- 10 pennies
Penny spread- 17 pennies

# data[].attributes.body
Some of the challenges we faces was that our beam would not hold anything, so we put a support beam in the middle to support it.
we had to work around he fact that the bridge had to be 12 x 3 inches.

# data[].attributes.body
Me and my partner decided to do a beam bridge because we figured it be easiest for us to do. Our idea was to roll up two pieces of paper and have them as the support four our beam(one sheet of paper).

# data[].attributes.body
Our model bridge must have a length of at least 12 inches, and a width of a least 3 inches, and support the weight of pennies. and it should be designed to allow boats to pass below the bridge as well.