# data[].attributes.body
I heard that we had to do 2 activities each and I'm not to sure about that but I'm just doing 2 just in case.

# data[].attributes.body
Technology: Is mostly about making and developing things that people find useful such as bicycles, diesel engines, satellite television and hang-gliders.
Science: Is about discovery. Scientists are people that are curious about how the world works. They as What, Why, Where, how questions like that. Science is about curiosity and finding out what's going on. It is important part of how humans find the truth about things. Science is not just about learning facts. As well as asking questions, scientists have a particular way of getting answers. This is called the scientific method.

# data[].attributes.body
When doing an experiment, start off with a hypothesis and state what you think will happen through the experiment. Begin the experiment and make observations and write them down on a recording table for example. Once the result has been found out, make a conclusion about what the results tell you about your hypothesis and add notes about what went well and what could be improved.

# data[].attributes.body
Independent variable is what you change or controlled in a science experiment.

Dependent variable is what you what you observe and measure in a science experiment.

Control variable is what you keep the same in a science experiment.

In each fair test you can only change one factor at a time and keep all the other conditions the same.

When doing an experiment make sure to repeats the trial for a few times to make sure the results is correct.

# data[].attributes.body
1. The funnel is for holding filter paper when filtering a liquid or fluid.
2. The conical flask is for chemical reactions with larger amounts of liquid.
3. The test tube is for chemical reactions with small amounts of liquid.
4. The Bunsen Burner  is to produce a flame and heat things.
5. A measuring cylinder  is for accurately measuring the volume of a liquid.
6. A beaker is to hold a large amount of liquid.

# data[].attributes.body
1. Get Bunsen Burner, tripod, tile, and matches or strikers.
2. Put the Bunsen Burner on the tile.
3. Plug the tube of the Bunsen Burner into the gas outlet in the wall, MAKE SURE THAT IT IS PLUGGED IN PROPERLY, or gas might go everywhere, and that might create a explosion when you try to light it.
4. Make sure that the hole is closed by the collar.
5. Get the matches or strikers ready, and open the gas outlet. Then, as quick as you can, light the match above the mouth(or strike the strikers above the mouth). This should create a flame.
6. If you want to make the flame hotter,  pull down the collar to expose the air hole.
7. To turn it off, close the air hole and close the gas valve. Then put away all equipment.