# data[].attributes.body
2.2.2.1.2. Faja load (AASHTO Standard, sectionng 3.7.1.2.)

The belt load is a uniform load per linear meter of ved transit combined with a concentrated load (or two loadsconcentrated in the case of continuous placed) on the beam sections, in positionng that triggers the maximum efforts

# data[].attributes.body
trucks standards

The truck design takes a track width of 3.05 transit

(Meters, placed on a road design 3,66m

Wide; debecolocar this truck design on each track, along the road, many times comovías design can be placed on that road. Fractions of transit routes should not be considered. However, for shod with wide

between 6.1 and 7.32 should be considered two-way design, each with

a width equal to half of the road.

Table 3.201.5.C Manual Highway Vol. III, indicates

track widths and berms to use depending on the category of the road. By

Road suggestion Valdivia, herein width 4 was used nclud the berm

# data[].attributes.body
It should not be easy to cancel or put out of service.

# data[].attributes.body
They will not cause any additional risk.

# data[].attributes.body
They will be of robust construction.

# data[].attributes.body
Preventive measures are intended to protect not only operators but to anyone else who may be exposed to these hazards.

# data[].attributes.body
Objects that foreseeably could be thrown or accidentally falling.

# data[].attributes.body
Objects that fall or projection is normally linked to the operation of the team

# data[].attributes.body
Emergency stop

Each team must be provided with an actuating member to a complete stop safely. The stop command team will have priority over the start-up

# data[].attributes.body
Start up

The launch of a team may only be effected by deliberate action on a control device provided for this purpose. Also after a stop.

# data[].attributes.body
Self-employed must comply with the provisions of the Health and Safety Plan.

# data[].attributes.body
Address the instructions and comply with the instructions of the coordinator for safety and health during the execution of the work or, where appropriate, of the construction management.

# data[].attributes.body
AASHTO STANDARD PROVISIONS STANDARD

SPECIFICATIONS FOR HIGHWAY BRIDGES.

# data[].attributes.body
Using teams which meet the provisions of Royal Decree 1215/1997 laying down minimum safety and health requirements for the use by workers of work teams are established.

# data[].attributes.body
Adjust his performance in the work according to the duties of coordinating business activities including participating in any measure of coordinated action had been established.

# data[].attributes.body
Comply with the minimum safety and health from location, maintenance, lighting, etc.

# data[].attributes.body
Work of "vertical" type, such as superstructures assemblies, antennas, special cleaning, etc.

# data[].attributes.body
Bricklaying or different where it is necessary to use scaffolding

# data[].attributes.body
Tasks restoration of buildings or works of art

# data[].attributes.body
Execution facilities or the like where it is necessary to access the work area or climb a ladder surface;

# data[].attributes.body
Any maintenance and repair

# data[].attributes.body
Risk tasks.
There are diverse work in which this risk can

# data[].attributes.body
AASHTO STANDARD PROVISIONS STANDARD

SPECIFICATIONS FOR HIGHWAY BRIDGES.