# data[].attributes.body
attached handle

# data[].attributes.body
put 4 sea shells, 2 on each side of the starfish

# data[].attributes.body
attached it and cleaned it up

# data[].attributes.body
sea shell cutout

# data[].attributes.body
attached it to mug and cleaned it up

# data[].attributes.body
cut out starfish

# data[].attributes.body
started to scrape it down all the way but it was hard so i realized i could just fade it away

# data[].attributes.body
did the line of where i wanted to make the top thicker

# data[].attributes.body
put it all together, but then I realized it wasn't going to stay on the background well and so I just didn't put it on.

# data[].attributes.body
rolled these out to make the lines of the cage

# data[].attributes.body
joined the two ends to make a circle

# data[].attributes.body
rolled this out to make the bottom of the cage

# data[].attributes.body
added body and ripped the wings a little from the sides

# data[].attributes.body
put little pieces of clay to make the wings stay up

# data[].attributes.body
added butterfly to the background

# data[].attributes.body
thinned out the edges

# data[].attributes.body
decided instead of doing 4 separate wings, I'm just going to do one whole body

# data[].attributes.body
was so thin it ended up ripping ):

# data[].attributes.body
cut out other bottom wing and thinned out the edges

# data[].attributes.body
thinned out edges

# data[].attributes.body
finally got a good shape

# data[].attributes.body
redid bottom wings but i couldn't get the shape right

# data[].attributes.body
put them all together but then I realized the bottom wings were way bigger than the top ones

# data[].attributes.body
feathered it

# data[].attributes.body
before i thinned it out this was the thickness of the wing

# data[].attributes.body
cut out both bottom wings

# data[].attributes.body
did both top wings, got them feathered and thin as possible

# data[].attributes.body
feathered out the edges

# data[].attributes.body
cut out first wing