# data[].attributes.body
https://en-gb.padlet.com/mm3crt/k0vqm4snqcpu

# data[].attributes.headline
SIZE and FRAME RATE: After switching the camera on using the ON button, press the MENU button to open it on the viewfinder.

# data[].attributes.subject
SIZE and FRAME RATE: After switching the camera on using the ON button, press the MENU button to open it on the viewfinder.

# data[].attributes.body
After opening the MENU, scroll down it by touching the arrows and pressing RECORD SETUP.

# data[].attributes.body
Through RECORD SETUP, you will be able to view and change your RECORDING FORMAT including your size (K), frames per second (p) and bit rate (M) as seen in the image below this post.

# data[].attributes.body
WHITE BALANCE: To alter the white balance, press the W.B button on the left side of the camera to open on the menu.

# data[].attributes.body
Use the SEL/PUSH SET node on the left side of the camera to change your white balance. 3200K, as seen below has a cold, clinical look which can be useful outdoors, but not in this shot.

# data[].attributes.body
As you can see below, the warmer look of 5600K is more suitable for an indoor shot.

# data[].attributes.body
ISO: There are differences between ISO and GAIN, but for all practical purposes, they relatively have the same effect on the video. To change it, press the gain button on the left side of the camera and turn the SEL/PUSH SET node to increase or decrease the light sensitivity of the image sensor as seen in this post and the one below it.

# data[].attributes.body
MICROPHONE application: After plugging your microphone into either INPUT 1 or INPUT 2, you must set the correct setting for your OUTPUT, which could be a lavaliere, a shotgun mic, CD player etc. For these you would set the input of mic, 48v and line respectively.

# data[].attributes.body
APERTURE: A method of changing your APERTURE range and exposure is with the IRIS RING at the very front of the camera.

The F-STOP will show you the fraction of how much light could be captured on the viewfinder, as seen below. To change the F-Stop press IRIS and twist the ting closest to the ND filter button.

# data[].attributes.body
SHUTTER SPEED: To alter the SHUTTER SPEED, press SHUTTER to show the Shutter cog symbol on the viewfinder on the bottom left of the screen, shown in the post below this one. Dream sequences would benefit from a lower shutter speed, whereas action scenes would benefit from a crisper more intense aesthetic.

# data[].attributes.body
The NEUTRAL DENSITY FILTER allows you to block out light without under exposing your image, which is useful when shooting in bright daylight. It can be manipulated using the the button seen below.