# data[].attributes.body
First, the car goes down the ramp, hits the dominos and makes them fall over, then the dominos hit the cup which pulls the jenga block, which pushes the car into more jenga, which falls into the box. We were able to work about 3 steps consecutively. The most challenging step was making the cup pull the jenga block. I would change the last step.

# data[].attributes.body
My video game is a game where you are a rainbow ghost (Nyshant) and you are trying to find your pet turtle Sheldon. The bosses are a robot, and evil bats. I think my game turned out pretty good and it works well. I would change characters if i had more time.

# data[].attributes.body
Our challenge was to create a cardboard candy dispenser that can release a specific amount of candy. I built the prototype with cardboard, wooden skewers, rubber bands, and hot glue. On the top of the prototype, there was a button that you could press, and it would dispense a gumball. My prototype worked because as the button was pressed, it would open up the hole in which the gumball would go through.

# data[].attributes.body
We were challenged to make a pinball machine that worked. Our pinball machine was beach themed. It had A surfboard obstacle, a beach towel obstacle, a ocean obstacle, and a sunscreen obstacle. The thing I liked most about our design was the back board of the machine. We could improve the flippers, and make walls behind them so the ball wouldn't get stuck.

# data[].attributes.body
We were supposed to make a device that could make noise or move with the makey makey kit. Our device was a piano, that played weird sounds. It worked by hooking the clips to pieces of foil as piano keys. The piano did make noise. I think the design worked because we had everything hooked up and connected.

# data[].attributes.body
Boat data table

# data[].attributes.body
We were challenged to make a boat that could hold 40g and travel 20in. Our boat held 40g, but could not travel while holding the weight. Next time, I would make our boat wider, so the weight would distribute, and I would also make the sticks that hold the rubber bands wider, so we could have a bigger propeller.

# data[].attributes.body
The challenge was to make a bridge out of pasta, that could hold 5 pounds. Our bridge held 4 pounds. If we were going to improve our design, we would make the base stronger.

# data[].attributes.body
We were asked to make a device that could stop an egg from breaking from a 30 ft drop. It did not survive the fall. If we could improve our design, we would add more straws

# data[].attributes.body
We were supposed to be a catapult that could hit the target 8/10 times. While competting, we hit 4/10 times.