# data[].attributes.attachment_link.entities[].name
Boss OD3 Overdrive Electric Guitar Pedal

# data[].attributes.body
WHAT IS IT?
its a technique used in sound recording and mixing

HOW IT WORKS
It is achieved by using two different compressors in a signal chain. one compressor generally stabilizes the dynamic range of all the other aggressively compress stronger peaks

USES
Compression often used to make music sound louder with out increasing its peak amplitude.

# data[].attributes.body
A noise gate or gate is an electronic device or software that is used to control the volume of an audio signal. Comparable to a compressor, which attenuates signals above a threshold, noise gates attenuate signals that register below the threshold. However, noise gates attenuate signals by a fixed amount, known as the range. In its most simple form, a noise gate allows a signal to pass through only when it is above a set threshold: the gate is 'open'. If the signal falls below the threshold, no signal is allowed to pass (or the signal is substantially attenuated): the gate is 'closed'. A noise gate is used when the level of the 'signal' is above the level of the 'noise'. The threshold is set above the level of the 'noise' and so when there is no 'signal', the gate is closed. A noise gate does not remove noise from the signal. When the gate is open, both the signal and the noise will pass through. Gates typically feature 'attack', 'release', and 'hold' settings and may feature a 'look-ahead' function.

# data[].attributes.body
A noise gate or gate is an electronic device or software that is used to control the volume of an audio signal. Comparable to a compressor, which attenuates signals above a threshold, noise gates attenuate signals that register below the threshold.[1] However, noise gates attenuate signals by a fixed amount, known as the range. In its most simple form, a noise gate allows a signal to pass through only when it is above a set threshold: the gate is 'open'. If the signal falls below the threshold, no signal is allowed to pass (or the signal is substantially attenuated): the gate is 'closed'.[2] A noise gate is used when the level of the 'signal' is above the level of the 'noise'. The threshold is set above the level of the 'noise' and so when there is no 'signal', the gate is closed. A noise gate does not remove noise from the signal. When the gate is open, both the signal and the noise will pass through. Gates typically feature 'attack', 'release', and 'hold' settings and may feature a 'look-ahead' function.

# data[].attributes.body
1.An effect whereby the sound produced by an amplifier or an amplified musical instrument is made to reverberate slightly.
2.The amp has a small output stage (about 1 watt) that sends the guitar signal out to drive the tank. The springs get excited with teh sound and create the reverb sound. Then a "recovery" stage (similar to the input stage your guitar plugs into) brings the reerb signla back in and mixes it with the straight sound.
3.The reverb projects the mental image (and other associated sensations) of the imagined space in which the sound was recorded. Reverb is used for a few different reasons in a mix. Reverb can also be used as a creative effect or sound design tool.

# data[].attributes.body
chorus

# data[].attributes.body
They are modulation effects, that utilize a bit of delay and alter that delay over time while playing.  This causes harmonics to phase cancel and  creates a sweeping up and down sound with the instrument or sound.

Chorus works similarly in the way that it uses the same effect, but over a more specific frequency range. da dum tss

# data[].attributes.body
equalization is the process commonly used to alter the frequency response of an audio system using linear filters.
How does Equalization work? Equalization adjust the amplitude of audio signals at particular frequencies
Why would we use the Equalization? Equalization may also be used to eliminate or reduce unwanted sounds or make the voice on a mic sound louder.