# data[].attributes.body
A voltage regulator compensates for excess and spare voltage by dispersing it evenly.

# data[].attributes.body
A zener diode allows a current to move forward as well as backward when the voltage is higher than a certain value.

# data[].attributes.body
A series pass transistor converts inbound voltage into a lower constant voltage.

# data[].attributes.body
Pulse-width modulation (PWM) is a method that is used to control the power that is going to an electrical device.

# data[].attributes.body
If a current is an incoming current, it is running towards the object, not away from it.

# data[].attributes.body
Output is the voltage, sound, or anything else that a speaker or other object produces.

# data[].attributes.body
To detect is to notice an object or a change in pattern.

# data[].attributes.body
To alter a sound is to change it.

# data[].attributes.body
To regulate a current is to control it.

# data[].attributes.body
To charge up a battery, is to allow it to accumulate the power needed to run.

# data[].attributes.body
Voltage regulator helps to not overload the circuit.
We should get a voltage regulator to be sure of what are we doing.
voltage regulator is really useful but expensive at the same time.

# data[].attributes.body
Zener diode is not an usual diode.
Zener diode in some situations is more useful.
Zener diode is transparent.

# data[].attributes.body
Series pass Transistor is useful to have an stable current.
Series pass Transistor is not commonly used.
Series pass Transistor is easy to represent.

# data[].attributes.body
Pulse-width modulation is represented in a graph.
Pulse-width modulation is useful to control the meassurement.
Pulse-width modulation has to type of graphs.

# data[].attributes.body
The incoming current is unestable.
The new incoming current is causing an overcharge!
You should check the incoming current to be sure.

# data[].attributes.body
You should check the output signal
The output signal isn't working.
Output signal is in blank.

# data[].attributes.body
The circuit detect a failure.
This PCB can't detect the resistor.
You should try to detect the signal with a tester.

# data[].attributes.body
You can alter the value changing the resistor.
Alter the value could be risky.
Some defective component can alter all the voltage in a bad way.

# data[].attributes.body
Don't alter the value, just try to regulate it.
Regulate the voltage can make it more stable.
Regulate the voltage of the output could be the solution.

# data[].attributes.body
The car use a battery, you should charge up.
Charge up the circuit battery can make it work properly.
The Battery is too low, you need to charge up.