# data[].attributes.body
Materials: Wood (mdf board)
Duck tape
Glue gun
Steps:
First of all you need to measure the sides of your camera. 4 of the peices of wood will be for the front, back,bottom and the lid. The other 2 pieces are for the sides.
To assemble I would start with the bottom pannel, start by putting the glue along the side if the wood so you can stick the front/back pannel on. Try and stick the peices of wood together as close as possible to make it light tight.
After the fron back and bottom are assembled you need to attach the smaller pannels on the side, after they have stuck using the duck tape go around the edges to make sure no light will get in. Once all the sides are stuck you need to make a whole in the front and put a piece of paper with a pin hole through it behind the hole. After this you can start with the lid.
For the lid I used glue and duck tape to fully secure it. You can either have a lid that flips or you can create a lid which comes off completly.

# data[].attributes.body
Unfourtunatley I have not yet created a image using my camera, because someone was using it for their solarisation.
I will be completing it this week. Although I have not yet produced my image for this process i have used a pinhole camera before, however I only exposed it for about 10 minuets. This was in the summertime a few years ago and the print came out very well, I think this was because the camera was professionaly made. When I was exposing I had a stand to make sure there was no camera shake.

# data[].attributes.body
To take a picture using the camera you must be in a dark room so the photo sensitive paper doesnt now contact light. Once you have your paper you have to secure it in the back of the camera, obviously making sure that you dont stick it on the side where the hole is.
Once you are all secure and setup you can place in a palce where no one shall move it, there you can leave it to expose for a week or however long you wish.

# data[].attributes.body
After you have taken your photograph, when you think you have left it for the right time. Do not open the lid in daylight you must only open it in the darkroom. Once the paper has been removed you need to develop as you would normally in the darkroom. Once the picture has been developed you will see it looks like a negative or if you have successfully managed the right time it will be clear and black and white. It's very important that you read about specific timing depending on the weather, for example if it very bright you only need to leave it for a short time whereas if you are taking a photography at night time you will need to leave it for hours.

# data[].attributes.body
You have a light proof box with just a tiny hole at the front or side. In the diagram below you can see how tiny the hole is, as well as how light enters and what happens in the box.  Now where the tree is printed on the back of the box that is where you place the photographic paper. Depending on where and what you are taking a picture of and how much light you will need to enter the box. This will determine how long you will have to leave the camera out.

# data[].attributes.body
A pinhole camera is a very basic camera, the way it is designed is you make a box that lets no light in except a pinhole. The pinhole acts as a lens and most importantly a aperture. Pinhole is very similar to a camera obscurer, now it is read that Aristolte spoke about pinhole camera as well as a camera obscurer, this was supposedly recorded during the 4th century. Apart from that the first recorded use was in China during the 15th century.