# data[].attributes.body
You equip yourself with an extraordinary apron at the front of the engineering classroom.

You then proceed to the back of the classroom and grab 2 bench hooks.

Place your mini shooting board allgined with the edge of the table

With your 2 bench hooks, you tighten the shooting board to make sure it stays in place when being used

# data[].attributes.headline
step 2 : the process of creating your wooden Tri-square

# data[].attributes.subject
step 2 : the process of creating your wooden Tri-square

# data[].attributes.body
Collect long piece of pine wood and drawn a line down measuring 175cm.

Once measured, you proceed to the shooting board with ur Tennant Saw and begin cutting a vertical line down the measured piece of wood.

Once completed, you measure out precise measurements horizontally of 5mm, 15mm, 20mm, 15mm.

# data[].attributes.body
Once you have all the measurements lined out, you proceed to the pillar drill and equip yourself with safety goggles.

The instructor will instruct us on how to carefully drill the wood.

When drilling, you should drill a mm away from the marked lines

once you have cut all the empty pieces you should return to the extra mm line and drill that out

Then you progress onto the other side and repeat the same thing until you can fit your fingers through the hole.

# data[].attributes.body
You take your wooden block over to your work station where you had previously clamped your shooting board to the edge of the table.

you armour yourselfs with a shooting plane and place your wooden block and the edge of the hook.

You proceed to roughly control the shooting plane and progressively move the plane smoothing the wooden block.

# data[].attributes.headline
drilling 3 holes into your wood and fitting things inside

# data[].attributes.subject
drilling 3 holes into your wood and fitting things inside

# data[].attributes.body
measure the hole to be placed in the centre of the connected plank so we can place the brass.

we use the pillar drill to drill the hole, once the hole is drilled we need to measure the brass so it can fit in the hole without too much excess to file down.

the brass measurement is 22mm and this needs to be cut by using the junior hack saw.

so we need to get a bench hook, metal rule, and a brass.

# data[].attributes.body
Equip yourself with a fat block with sandpaper wrapped around .

Begin smooting out your block ensuring it is smooth all over.

Smooth out for approximately 10-12 mins until your sure your block is smooth.

Smooth out every part of the block making sure every crevise is touched

# data[].attributes.body
Equip yourself with gloves and head to the back of the class.

Start to apply gentle amounts of varnish all around the wood until your comfortable.

If too much is applied then with a cloth gently rub some off

Once the varnish is applied you let it dry and your work has been completed

# data[].attributes.body
Thank you very much for attentively listening to my powerpoint on this impeccable wooden masterclass work of art.

Your regards Mr Mehmood.

# data[].attributes.body
A pre-eminent and spectacular tri-square created by a renowned engineer/ architect Mr Mehmood

# data[].attributes.body
175mm wooden block

# data[].attributes.body
Mortize driller

# data[].attributes.body
Brass inside your wood

# data[].attributes.body
- File the edge of the brass with a file so it is easier to fit the brass into the hole
- place the brass directly on top of the hole and with a hammer, you hammer the brass carefully into your wood
-Repeat this method 3x until each brass fits through each hole.