# data[].attributes.body
My very first attempt was a pretty good attempt but the clay was way to thin for the plate and caused many cracks. (Below is the leftovers from the first attempt)

# data[].attributes.body
My second attempt was even better than the first attempt but the cup was way too small to use. (no picture)

# data[].attributes.body
In my third attempt I took my second attempted peice and took off the cup and threw on another cup on top of it.

# data[].attributes.body
When i went to get the chip and dip peice there were too many cracks and apparently the plate base peice was way to thin and it broke

# data[].attributes.body
I have been having a hard time centering the center cup for some reason. I do all the techniques to center the clay but it won't center.

# data[].attributes.body
This attempt was my best attempt out of them all the cup was perfect and so was the walls.

# data[].attributes.body
when i went to take the peice off to trim it totally feel apart on me and all I did was add some slip to the clay.

# data[].attributes.body
My first attempt was a very decent attempt at the pot itself but when it came to the dish part i totally messed it all up. I tried to save the pot but it was so damaged at the bottom my best bet was to just throw it away and start over.

# data[].attributes.body
The second attempt turned out really good and its not totally perfect but it is so far looking like a fuctional peice.

# data[].attributes.body
My first attempt was pretty rough i couldn't get a cylinder thrown to start shaping the vase. (No picture)

# data[].attributes.body
Somehow on my second attempt i successfully threw a vase. The vase is shorter than what is expected but I am planning on sculpting some handles onto the neck and throwing another vase hopefully taller than the first.

# data[].attributes.body
Everytime i try to throw a cylinder i cannot get it evened out it just collapses upon itself. THe last few attempts that i did were better cylinders but they still somehow collapsed upon themselves. I still want to be able to throw the bottle and hopefully a chip dip before winter break.

# data[].attributes.body
I could not get the cylinder to be centered so i restarted. (no picture)

# data[].attributes.body
I had an almost perfect attempt for my second try but it is a little wobbly on the side i am planning on trimming most of the bottom out into more of a sphere but leaving a flat bottom.

# data[].attributes.body
I have so far made 2 cylinders to work with and carve into them this week/end. I have a plan for one of the cylinders to carve off peices from the top down towards the bottom or center to shape into a flame like pattern. I'm still trying to come up with a second creation for my second cylinder i may cut off a half of the lip (2 or three inches)
to create some weird handle like structure.

# data[].attributes.body
This is the flame design like sculpture i was going for

# data[].attributes.body
This was the idea of cutting off the lip and reshaping part of the other side of the lip.

# data[].attributes.body
I may turn this into a leaf.