# data[].attributes.body
The cords would go in through the holes and this would lay flat on the table. The two poles would be used to wrap the cords around when note being used.

# data[].attributes.body
After an interview with Jason with the first prototype, it was evident some things needed to be changed about the prototype to suit Jason's needs.

# data[].attributes.body
https://www.tinkercad.com/things/53C3rakX2wS-final-cord-holder

# data[].attributes.body
The arc on top is used as a handle and sticks up about 1 inch from the edge of the computer. The cord heads go into the holes and should stay in when pushed in and pulled out.