# data[].attributes.body
Need to put more weight in the bottom when cutting, need a more even cut. Walls could be thinner, especially at the bottom.

# data[].attributes.body
Goal was to make the walls straight up/make a cylinder. Need to improve on getting a straight wall.

# data[].attributes.body
I need to improve on my pulling technique. Make wall straighter up. Need to allow a thicker base.

# data[].attributes.body
Walls could be thinner, Need to practice lifting. Thinner base. Throughout the whole making of this, I felt like I needed more control over the lifting process. I couldn’t lift it up right and the cylinder I started off kept opening up.

# data[].attributes.attachment_caption
The walls are too thick. The walls are uneven, we can see that at the top where it’s slanted. The bottom was too thin. Very short.  Things I can do to improve is practice on my pulling, make sure the walls all end up even. Practice pulling more weight to the top of the cup. Not creating a hole too deep in the clay that way I have a good base for my cup.

# data[].attributes.body
Walls could’ve been more even. Need to practice on pulling and stretching. Need to improve shaping.

# data[].attributes.body
Random Dent on the bottom? Need to practice of shaping. Better the trimming (the foot was all uneven and not the best trimming job)

# data[].attributes.body
one horn

# data[].attributes.body
two horn

# data[].attributes.body
Added more texture, shaped horns (added more point)