# data[].attributes.body
Either divert the river by digging a canal that that diverts the flow of the river then build the dam in the river or use a crane to lower the pieces of the dam into the river.

# data[].attributes.body
Reservoir a large amount of water of water in a basin. Block this water from flowing via a damn structure and make several small access points where the water will flow through. In the middle of these slipways install several hydro electric turbines.
Profit

# data[].attributes.body
How do you build a dam? You build a dam by firstly making a plan. Starting with a barrier restricting a source of water into two. And that must have a some sort of flow passing by

# data[].attributes.body
Divert the river. Gather different sized sticks. Build a structure using the sticks, fill the gaps with clay. Allow water to enter dam.

# data[].attributes.body
Find a water source (eg river)
Build a wall to stop the water from flowing, using anything from sticks to concrete
Put holes in the wall that can be closed in order to let water go to stop overflow
Let the water build up

# data[].attributes.body
Divert the river, build a wall with concrete and Undivert the water into the wall. Then build another wall to stop the damn from getting bigger.

# data[].attributes.body
1. Diverting the river. Preparing the foundation for the dam. Building the dam with crisscrossing sections for support. - Concrete dam. - Embankment dam. Filling the reservoir. Testing floodgatesMonitoring the behaviour of the newly built dam

“Steps for Building Dams.” Britishdams.org, 2020, britishdams.org/about-dams/dam-information/building-dams/.

# data[].attributes.body
Start with making a foundation of wood. Fill the foundation with smaller sticks and leaves to cover it. Cover the whole dam with mud

# data[].attributes.body
First, observe the site for the dam. Second, make a design for the dam. Third, gather the materials for the dam. Fourth, start building the dam in the logical order.

# data[].attributes.body
Divert the water and cast a concrete slab. Then build a mound on the other side to add stability. Then create an overflow duct so that your dam does not erode away.

# data[].attributes.body
Dig a hole. Put sticks and pieces of wood to divide the water and slow down the flow of water. Fill the hole with water.

# data[].attributes.body
First take big logs and the stick them into the water vertically, then get a lot smaller sticks put them horizontally against the logs, once those are secure get a ton of mud and pack them into the structure until it’s all dry and no holes left

# data[].attributes.body
We would put pebbles and and wood sticks and cover it cement in middle of the body of water.

# data[].attributes.body
Find a flat surface with sand. Get a diggger truck and start digging. You put water in the hole and put a pipe to keep the water there and to refill the dam.

# data[].attributes.body
You have to divert the water, then put some steel then close the sides of the steels with wooden planks, then fill the middle with  concrete, then add more layers of concrete

# data[].attributes.body
Start with large loads and trees for structure and start moving your way down smaller sticks leaves mud

# data[].attributes.body
Start with large pieces of wood as a foundation, then slowly fill those pieces with smaller and smaller pieces until all of the holes are plugged, and add weight into it to keep it in place. Finally, add mud as a sealant.

# data[].attributes.body
First we get some beavers.
Then we ask the beavers to gather sticks and limbs.
Then the beavers pile up the sticks and limbs and weave them together and add mud to make a solid wall of debris.
Then we celebrate our new dam with some cake and punch.