# data[].attributes.body
Added individual teeth which turned out pretty good after adding on a bit of clay but once it hardens I will probably remove some of the clay holding them in

# data[].attributes.body
I also forgot to take a picture but on the surface of the skull i used a brush to texture it and created a rough surface with various imperfections rather than smooth

# data[].attributes.body
Got the handle done but I need to wait before attaching as it is pretty soft right now

# data[].attributes.body
Skull didn't turn out very good at first so I ended up with this but I went back and reshaped it

# data[].attributes.body
I made the eye sockets smaller and pushed them in a bit then I had to redo the brow ridge and added a bit more clay on the top to make it rounded

# data[].attributes.body
I cut off the top with a wire and hollowed out all throughout the skull and down by the teeth.

# data[].attributes.body
After I began adding on some more clay to pull out the nose and dug into it leaving a but in the middle I also increased the size of the sockets by quite a bit

# data[].attributes.body
For the Eyes I added on clay and began separating the two eye sockets leaving room for the nose although they started out a bit small

# data[].attributes.body
To start out I made a basic sphere to begin sculpting the skull