# data[].attributes.body
When both parts of my project were finished I had a hard time attaching them to each other. My original thought was that I would just simply wrap the wire around the wire and it would be tight enough to stay attached. When doing that, it stayed but not permanently. If I touched it slightly it would fall off. So what i decided to do was cut a slit into the planet and slide the end of the  wire  into the slit. Then were the end attached to the planet I put super glue there and on a few other spots of the rose where it touched the planet.

# data[].attributes.body
When I finished my wire rose, I decided I wanted color in my piece. So I then thought of adding tissue paper to the rose. So then I mod podge the tissue paper onto parts of the rose. Places such as the leaves and some of the petals. I decided to leave some of them plank because I thought it gave it a good contrast.

# data[].attributes.body
A hard thing for me was to wrap the wire tight enough so it did not move. So I tried several different ways and used different tools to find which way best secured the wire. I then found the two tools that worked the best to wrap the wire around so they were fixed in place.

# data[].attributes.body
My idea was to make a planet out of decoupage. During the process my balloon popped to I tried my best to finish the planet without a support. It went better than I expected, It helped me give it a more circular shape. Although the paper did not lay as flat as it would have on the balloon, it actually gave it a good texture.