# data[].attributes.body
The weight was spread out on both ends and the middle but the space in between them was very week. The bridge spreads out the weight to the large support beams. Yes a suspension bridge because the wires are spread out through out the entire bridge not just the middle and sides.

# data[].attributes.body
Over all i did well but we kept having arguments about the best way to use our paper. not being partners we ended up doing my design and i worked well so WE NEED NEW GROUPS. I think i kept our builders straight and next time i will not yell as much i have anger problems.

# data[].attributes.body
Add supports to the entire bridge not just to 3 sections.If i had more paper i would build a suspension bridge but with the limited paper i would keep my current design.

# data[].attributes.body
We built a bride that had a road of 13 in long and had three support pillars and we made it tall enough for boats to pass under it.
Our bridge held 155 penys stacked and only 23 spread the stacked worked beter because the paper thats on top the beams was strong put the paper n between was week

# data[].attributes.body
A difficulty that we had was the limited amount of paper and tape.
We only had a couple of paper and two feet of tape
We had to build a bridge that could hold the weight of hundreds of penny's

# data[].attributes.body
to build many little wire like shapes out of the paper then we realized that we would  not have lots of paper.
We divided it build a beam bridge because it is simple cost friendly and strong.

# data[].attributes.body
The problem was to build a bridge that could support the weight of hundreds of penny's.