# data[].attributes.body
Finally put you finished flower onto a black cardboard sheet and connect it on firmly with thin wire.

# data[].attributes.body
Slip the bezel onto the top of the stem loosely. Then three the wire you previously solder onto the inside of the bezel through open holes on the center dome to connects them

# data[].attributes.body
Cut a small piece of metal but make sure it will be bigger than the top circle on your stem. Then make it into a circle using the metal bar and rawhide hammer. Solder the end of the metal place together using medium solder so that the bezel stays together. Also solder two 16 gauge wires onto the inside of the bezel, and then polish.

# data[].attributes.body
To start off your flower, cut out a medium sized circle with the hole punch and then used the drill to drill a pattern of holes into your circle which will later be used to connect the pedals onto it.Then use the square with the holes in it to make the circle into a small dome which will be the center of your flower. If some of the holes you previously made in the dome got smaller of faded you can go over the holes again with the drill.

# data[].attributes.body
Cut six short pieces of 20 gauge wire and thread the wire in one hole and back out the other so both ends of the wire are on the inside of the pedal. Then use hard solder to soldier the wire onto each pedal so there is no movement (make sure you solder the wire on the back side of the pedal, or the side that does not have to ends of the wire on it.) Go to the polishing station and carefully polish each pedal on the slow mode. If there is black smudges on your pedals then rub you pedals with pumas and water to get it off.

# data[].attributes.body
Next you start the steam. To figure out what size steam you need take a string and measure the circumference of the dome (center of flower) and then that length string laid out straight is the length medal you need to cut for you stem. Use the silhouette closest to that size string length , and cut it out and glue it onto a nickel silver medal sheet. Go get the wood block and saw blade and cut out the cone. Use a rawhide hammer and a narrow metal hammer to turn the metal lay out into a cone or your stem.

# data[].attributes.body
File down the edges of the pedals so they are smooth and not sharp. Use the pliers to bend and shape the pedals so they look more realistic and show movement. Then, use the drill again to drill two holes and the bottom of each pedal and then file the sharp edges down again.

# data[].attributes.body
Next, start to make pedals. Draw 6 pedal shapes on a pieces of paper, cut them out, and then glue the cut outs of the pedals onto a large sheet of copper metal. Make one extra pedal just incase you mess up during the making of your flower. Then you will grab a wood block and a saw out the pedals