# data[].attributes.body
I think me and my partners got along on some parts and then others we wanted to do different things and argued about what would work better.

# data[].attributes.body
Some things I would do differently next time would be that i made sure all the beams at the bottom holding up the top half of the bridge were all the same size and maybe spread out a little more to support the entire top half.

# data[].attributes.body
The model my group build was originally suppose to be a suspension bridge but later on into the building proses we found that it would be much easier to make a beam bridge. The beam bridge was flat on top and had beams holding it up.

The test results were that we had 15 when we stacked the pennies and 102 when we spreaded them out along the entire bridge.

# data[].attributes.body
Some difficulties my group had while planning and designing our bridge was that the tubes weren't long enough and the beam of the bridge wasn't thinck enough to hold everything together.

Some constraints we had to plan around were not having enough paper and tape to finish and running out of paper from messing up too much.

# data[].attributes.body
A beam bridge carries all of it's weight throught the beams. There is poles coming from the ground into the beam of the bridge and the weight comes through the beam and applies pressure onto the rods holding the bridge up, stable, and together.

# data[].attributes.body
Some ideas my group suggested before we finally picked was making a suspension bridge but realized while making it that it would be much better to turn the bridge into a suspension bridge.

# data[].attributes.body
The initial problem that we are trying to solve is that we need to build a bridge made out of only paper and tape and it must pass a weight test.