# data[].attributes.body
Task 9 4/6/20 Prom
You could leave the ponytail as is or create a bun as shown below. I held the bun in place with clips and sprayed with hair spray all over to hold.  A pretty tiara would complete the look.

# data[].attributes.body
Task 9 4/6/20 Prom
I took a small section from the side and created a braid that led to the ponytail and clipped in place. I then dressed the front sections inline with the braid towards the ponytail and clipped in place. The hair had a curl in it which made it easier to style.

# data[].attributes.body
Task 9 4/6/20 Prom
Sectioned the hair- 2 sections each side and put a low pony tail in place leaving section at the back/top out of the ponytail. Taking one section at a time from the back section I teased the hair at the root to create a beehive at the crown. Once created I pinned in place just above the ponytail.

# data[].attributes.body
Task 8 21/5/20 long graduation 180 degree cut. For the front sections I cut 1 finger width across the top along the centre parting from crown to front using crown as marker. Once complete I did chocolate orange sections on each side cutting 180 degrees using top parting hair as marker, not cutting any shorter lengths allowing them to fall away. I crossed checked layers once completed cutting.

# data[].attributes.body
21/5/20 Task 8 180 degrees long graduation, wet cut, started on the length perimeter then secondly at the crown of the head. This was used as my marker for cutting the back. Sectioned into chocolate orange sections at the back holding the hair at 180 degrees, letting anything shorter fall away. Using crown as my marker.

# data[].attributes.body
21/5/20 Task 8 long graduation cut 180degrees before and after, Chelsea blow dry, used heat protector and shine spray

# data[].attributes.body
Task 7 13/5/20 before and after. 2 after pictures . Sprayed with hairspray to hold 2 rolls on top of head and hold 40s wave in place at the back. Enjoyed doing this, found it useful using curling tongs to create the look and enjoyed researching different 40s look.

# data[].attributes.body
Task 7 13/5/20 when pin curls cooled remove back ones and brush through creating a wave. It can frizz a little so I used a shine tonic to smooth and control frizz creating a smooth 40s wave at the back. Then remove pin curls at 2 front sections and brush through 1 section, tease with tease brush to create volume and create 1 large roll curl with fingers away from the face. Pin it with clips to hold in place on top of head. Do the same with the 2nd section.

# data[].attributes.body
13/5/20 Task 7 1940s victory curls and wave. Section hair in 2 parts at the front with side parting and clip the back. With a curling tong curl 2 parts at the front, curling away from the face and hold with pin curl. These 2 sections are for 2 victory curls. Then curl with tongs the back starting at the bottom curling the same way from left to right and pin with pin curls. Once complete sprayed with hold spray and let cool.

# data[].attributes.body
6/5/20 Task 6 T section foils, before, during and after- sectioned hair and weaved hair cross top of hair from back to front, did each side and lastly fringe. Used bleach with 9% developer, ratio 1:2, 40 mins developing time.

# data[].attributes.body
30/04/20 Task 5 finished finger wave using clips hidden underneath to hold curl flat to head and sprayed with hairspray. Quite hard to do for the first time but enjoyed practising

# data[].attributes.body
30/04/20 Task 5 before finger wave

# data[].attributes.body
30/04/20 Task 5 during finger wave, curled side section split into 3 with curling tong and held curl in place with clips. Let it cool down then removed 3 clips and brushed through together. Using a comb and fingers I set hair and clipped again into place down the side of head.

# data[].attributes.body
30/04/20 Task 5 before finger wave

# data[].attributes.body
23/4/20 Task 4 starting regrowth colour application, put into 4 sections hot cross bun, use clips to hold in place

# data[].attributes.body
23/4/20 Task 4 completed regrowth colour, using effliarage and rotary movements just before removing colour to emulsify and remove colour from scalp and hair line, blow dried straight and smooth using serum after drying

# data[].attributes.body
23/4/20 Task 4 regrowth colour application, starting at the top for shortish hair, colour roots only, moving down each of the four sections, hairline at the front do last,  cross check at the end so ensure full application, develop for 30 mins

# data[].attributes.body
23/4/20 colour formative 1d end result bleached again then added 8.1 light ash blonde on to ends to create dark blonde highlights on ends, blow dried and curled with wand, used heat protector and shine tonic

# data[].attributes.body
23/4/20 colour formative 1c during, high lighted ends of hair using board method, blow dried and curled using wand

# data[].attributes.body
23/4/20 colour formative 1b products used, bleach 40 vol, added magi bond to bleach mix, developing time 30 mins, blue shampoo applied after removal of bleach to tone red. Used board method to highlight ends of hair

# data[].attributes.body
23/4/20 Colour formative 1a before highlights ends of hair using board

# data[].attributes.body
2.4.20 task 3a after graduated bob

# data[].attributes.body
2.4.20 task 3b during graduated bob

# data[].attributes.body
2.4.20 task 3c before graduated bob