# data[].attributes.body
carving the mask out

# data[].attributes.body
finished mask

# data[].attributes.body
handle that i’m going to add

# data[].attributes.body
i still need to add the handle

# data[].attributes.body
the glaze covered my signature

# data[].attributes.body
trimming today

# data[].attributes.body
trimming and making handle today

# data[].attributes.body
My floor is too thin

# data[].attributes.body
My walls were too thin and the clay was too wet so it collapsed when I did a cross section

# data[].attributes.body
This is very lopsided, I need to slow down on the pulls and when I get to the top I need to slowly let go, not quickly

# data[].attributes.body
I need to trim the top so it is even.

# data[].attributes.body
I got it to just under 7 inches, I need to have a consistent shape, but when I was trying to even out the walls on another pull it broke.

# data[].attributes.body
The wall thickness is uneven

# data[].attributes.body
The sides on the bottom are a little too thick, I need to undercut more and have a thicker base as well because it is thin.

# data[].attributes.body
When I opened the pot I went to far, there was also water at the bottom which then caused it to be too thin on the base.

# data[].attributes.body
On one of my pulls I made one side too thin, so when I shaped it and put a bubble in it the thinner side started to collapse.