# data[].attributes.body
One modification we made was to make additional supports to keep the table from falling under the weight of a book.

# data[].attributes.body
! thing i had to change is the way the legs moved or had to stand.

# data[].attributes.body
we tried to make it so that the legs would be support but we (Imani) failed

# data[].attributes.body
We have to add additional supports to prevent the legs twisting to support a second book.

# data[].attributes.body
One modification that we made was we made 3 legs with 2 half pieces in each leg and held up 5 books but it fell before we got to take the picture.

# data[].attributes.body
One modification we made was to separate the legs to each corner instead of having the legs of the table stuck together.

# data[].attributes.body
1 modification we made to our paper table was we made a couple paper triangles to make the table

# data[].attributes.body
We have not made any changes to our table because we have not tested it yet.

# data[].attributes.body
Haylee
Mackenna

We decided to not put a line of newspaper on the bottom because it would make it tip over.

# data[].attributes.body
One modification we made was cutting down the tubes on the side. We did this because the design was slanted and not flat on the top.

# data[].attributes.body
One modification that i made was add a small bar of newspaper on the bottom on my table.

# data[].attributes.body
one modification we made was making more stable legs

# data[].attributes.body
One modification I mad to are design is that we are going to add more stilts so it can hold more weight / books.

# data[].attributes.body
One modification that I made is w decided to make a new design of triangles and see how that goes. then with the extra paper, we will create supports.

# data[].attributes.body
One modification I made was to fold the really long newspapers into a triangle on top because they were too long.

# data[].attributes.body
One modification I have made is ........ this is because.......