# data[].attributes.body
1.- balanza | balance
2.- cápsula de Petri | glass plate
3.- cubeta cromatográfica | developing tank
4.- mortero | mortar
5.- soporte | stand (ring stand)
6.- vaso de precipitados | beaker

# data[].attributes.body
material laboratory

# data[].attributes.headline
II. INSTRUCTIONS FOR WORK IN THE SOIL PHYSICS LABORATORY

# data[].attributes.subject
II. INSTRUCTIONS FOR WORK IN THE SOIL PHYSICS LABORATORY

# data[].attributes.body
Among the care that should be taken in a soil laboratory are mentioned, mainly, the following:

• Do not throw the floor in the laundry or tarjas. The soil must be emptied in waste containers to be later taken outside.

• Ensure that instruments are calibrated and standardized at their reference point.

• make sure the scales are level.

# data[].attributes.body
The physical characteristic of soils has as main objective the response of the soil to the practices in the different production systems, as well as the susceptibility of the soils to undergo some process of degradation.

The physical properties of the soil are related to the capacity that this has to offer different uses that are of benefit for the human being. For good use, conservation, management and recovery of the soil resource, it is necessary to know the fundamental fundamentals of the physical characteristics of the soil. The productivity of a soil depends not only on its nutritional content, but also, on the physical conditions of the soil, conditions that are sometimes not determined. It must be remembered that the development of the aerial part of a plant depends on the development of the root, which, in turn, will depend on the soil having a good balance of aeration and humidity.

This manual aims to be a guide for students and academics that require the analysis of some physical properties of soils. Therefore, the analytical procedures to estimate and determine, in the field and in the laboratory, the main physical properties of the soil

# data[].attributes.headline
IV. NORMS OF COMPULSORY COMPLIANCE FOR WORK IN LABORATORIESGeneric rules

# data[].attributes.subject
IV. NORMS OF COMPULSORY COMPLIANCE FOR WORK IN LABORATORIESGeneric rules

# data[].attributes.body
New personnel must be immediately informed about the work rules, the safety plan and the laboratory, and the specific characteristics of the dangerousness of the products, facilities and operations normally used in the laboratory. This norm should also be extended to visitors and personal users eventually hired from all levels.

Then, make a series of recommendations, which should be followed systematically in the laboratory.

> Personal habits and clothing:

# data[].attributes.body
- It is the responsibility of the laboratory personnel to work with care and responsibility.

- It is the responsibility of the laboratory personnel to ensure the proper use of the equipment, instruments, reagents, solvents, samples, tools and materials that are being used by this

# data[].attributes.body
What are they?

Help elements in case of emergencies (spills, splashes, spills, etc.). They must be kept in good condition and within reach so that they can use it as quickly as required, as well as properly marked.

Collective protection equipment most common in the laboratory

The laboratory has a series of safety performance elements that are described below and must be correctly marked.

> eyewash

It is a system that must allow the rapid and effective decontamination of the eyes and that is constituted by twice the sprinklers or nozzles capable of providing a stream of potable water to wash the eyes or the face, a battery of provision of an appropriate system , of a system of fixation to the ground or the wall and one operated of foot (pedal) or of elbow. The jet received by the nozzles should be low pressure so as not to cause unnecessary pain or damage.

> fire safety equipment

Alarms

The repairs are intended to alert you of the danger that all personnel working in the laboratory and all those who should be familiar with the exact location of the fire alarm that is near your laboratory.

Fire extinguishers

If it is not feasible to control the small fires that occur in the laboratory, due to its location, characteristics, persistence or extension, with fire retardant blankets or wet textiles, it is necessary to resort to fire extinguishers. Extinguishers are apparatuses that contain an agent or extinguishing substance that can be projected and directed on fire by the action of an internal pressure. Since there are many types of fire, which are classified according to the liquid, liquids, gases or metals, they must decide in each case the suitable extinguishing agent: water spray or a jet, powder, polyvalent powder, foam or CO2.

# data[].attributes.headline
1.- You should not have any activity without prior authorization or not properly supervised.

# data[].attributes.subject
1.- You should not have any activity without prior authorization or not properly supervised.

# data[].attributes.body
- no laboratory document is needed, to avoid its damage or loss. these must be employees and consultants within the laboratory.
-It is the responsibility of the laboratory staff to ensure good segregation and disposition of the waste after each practice.

# data[].attributes.headline
4.- The hair will always be collected. Will not wear bracelets, pendants, wide sleeves, hoods, scarves, etc.,

# data[].attributes.subject
4.- The hair will always be collected. Will not wear bracelets, pendants, wide sleeves, hoods, scarves, etc.,

# data[].attributes.body
-the staff must wash their hands after handling hazardous materials, as well as before leaving the work areas of the laboratory

-It is advisable to wear long pants and, in general, clothing that prevents substances that may fall from entering the footwear or come into contact with the skin of the legs or feet.

# data[].attributes.headline
3.- The smock must always be worn (properly fastened) and the personal protective equipment required according to the type of work carried out.

# data[].attributes.subject
3.- The smock must always be worn (properly fastened) and the personal protective equipment required according to the type of work carried out.

# data[].attributes.body
-The use of lab coats or work clothes will be mandatory within the laboratory, according to the degree of risk to which the staff is exposed.
- safety glasses, visors or other protective devices should be used when it is necessary to protect the eyes and face from chemical splashes, or during the preparation of samples.

# data[].attributes.headline
6.- not receive visits or hold meetings in the laboratory: there are other more appropriate units for these activities.

# data[].attributes.subject
6.- not receive visits or hold meetings in the laboratory: there are other more appropriate units for these activities.

# data[].attributes.body
-the laboratory doors will be kept closed

# data[].attributes.headline
5.- use suitable footwear: do not wear sandals or other footwear that leaves the foot exposed.

# data[].attributes.subject
5.- use suitable footwear: do not wear sandals or other footwear that leaves the foot exposed.

# data[].attributes.body
-the footwear used in the laboratory must cover the entire foot.
- Disposable personal protection elements must not be reused