# data[].attributes.body
I would put it in a fire place or oven, so that way i could charge my electronics or store in batteries.

# data[].attributes.body
probably along the hot water pipes or with the water heater cause its usually super hot

# data[].attributes.body
I would put the TEG near my fireplace because its cold right now and we have the fireplace on a good amount so it would use thermal energy alot

# data[].attributes.body
I would use it to maintain a warm temperature in the home .

# data[].attributes.body
I would put it in the oven because it would use the heat to charge the batteries of any electronics.
~Joe Young

# data[].attributes.body
Depending on what season it is, I would either place it outside or inside. If it was summer time I would place it outside to collect the heat from the sun. If it was winter I would put it next to the fire place. I would then use the energy to power kitchen appliances so I'd be able to use a fridge or oven to cook.

# data[].attributes.body
I would put it in the oven so it would charge the batteries of any electronic in my area.
It can even charge a flashlight when the power runs out. when the heat probe gets the prime source of heat, it will be able to convert the heat into electricity.

# data[].attributes.body
We would put it in an oven so it could use the heat to charge things like batterys or electronics

# data[].attributes.body
I would put the TEG in both of my fire place so I can charge batteries
-Reece Phillips

# data[].attributes.body
Maybe in an automobile since there is a lot of exhaust gas that way the heat energy will not be wasted. Also an emergency power system if I where to have a power outage.

# data[].attributes.body
I would put the TEG by either a fireplace or near the heating system. Both of those places are a good source of heat and by positioning the other end somewhere else, it would create a temperature difference allowing electricity to be made. This electricity can be used to charge batteries or phones.

# data[].attributes.body
This method of using a TEG would only work in the summer time due to the heat from the sun, but I think an idea would be to hook the TEG up under the cement roads and allow the heat conducted to turn into electricity and be used throughout the houses.
-Summer Woods

# data[].attributes.body
I would use it to heat up the house or to charge my phone or anything else that I can charge or heat up..?

# data[].attributes.body
i would use for something that needs a heat source like an oven or batteries.

# data[].attributes.body
I would put the TEG in the oven because of the heat the oven uses to cook food. it would be a good source of thermal energy and from that thermal energy it can be distributed to other parts of the house. it can especially be used once the oven is cooling down once it is turned off after it has just been on.

# data[].attributes.body
~I would use it as a heat source to warm up the house.
~ I COULD use it as a source to charge electronics in my house because the TEG converts heat into electrical energy.
~ I could also use it as both. Like a fireplace & a charging port.

# data[].attributes.body
mmmm

# data[].attributes.body
I would put a TEG in my fire place to charge a load of batteries. These batteries would then provide power if the power was to go out. You can also use a TEG to power the fan in your kitchen that pulls out the cooking smells. If you place the probe where the heat rises it will become very hot and the kitchen fan will cool the other side so that there can be a flow of electricity.