# data[].attributes.body
(Part One

# data[].attributes.body
(Part Two)

# data[].attributes.body
(Part One)

# data[].attributes.body
(Part Two)

# data[].attributes.body
Press print (on the left) Barren print (on right)

# data[].attributes.body
There was high success with my single colour foam print. In this print the colour was very vibrant and on majority of the blocks ink was spread evenly - as well as having sufficient amount of ink. The blocks were also placed well on the paper. The main thing to improve on next time would be to add more ink / ensure ink is on the block and add more pressure - as the white spots were not wanted.

# data[].attributes.headline
Group Print Abstract Combination (Annotations)

# data[].attributes.subject
Group Print Abstract Combination (Annotations)

# data[].attributes.body
This group or triple colour prints; done from foam blocks, wasn’t really well done (none of them were). This one specifically, I feel like ir had something good contrasts of colours and the lack of pressure did make aspects of the print seem intentional and look appealing. Things that I could improve on with this Print, is the colour choice and also spreading ink. By spreading ink towards / on the edges more, adding more ink, and applying sufficient pressure when transferring the ink, could significantly improve this print.

# data[].attributes.body
My first Yin and Yang print didn’t seem appealing to me, therefore I did a second print that was to my standard and was (in my opinion) very well done. It had all elements-colour, repetition, etc- that were required. The amount of ink was good and the blend of colours was awesome. Although next time I could have used the texture of the wood block better, but overall the print was well done.

# data[].attributes.body
This is the first (bad) print

# data[].attributes.body
Part i

# data[].attributes.body
Part ii

# data[].attributes.headline
Hazards igns and Safety Symbols Task Sheet 

# data[].attributes.subject
Hazards igns and Safety Symbols Task Sheet 

# data[].attributes.body
Part i

# data[].attributes.headline
Hazards Signs and Safety Symbols Task sheet

# data[].attributes.subject
Hazards Signs and Safety Symbols Task sheet

# data[].attributes.body
Part ii

# data[].attributes.body
Part i

# data[].attributes.body
Part ii

# data[].attributes.body
Sketch

# data[].attributes.body
Stencl

# data[].attributes.body
Media Test Prin

# data[].attributes.body
Final Media Print

# data[].attributes.body
This is one of the ways I was going to fold but I decided to just cut out triangles with tabs so I could stick them together like a pyramid.

# data[].attributes.body
Part i

# data[].attributes.body
Part ii

# data[].attributes.body
Part iii

# data[].attributes.body
Part iv

# data[].attributes.body
Number one of many (I’m not sure how many I did but it is more than 6)

# data[].attributes.body
There wasn’t one final print, because there were alterations to all four designs I used three final prints, with the best looking designs on them. I but them all to the same shape and glued them together. I made sure I had tabs so that I could fold the designs into the desired pyramid shape.