# data[].attributes.body
We didn't get to do our 3rd Attempt.

# data[].attributes.body
The water dripped faster than the 1st attempt and we squeezed the cup whenever it stops dripping. We also got a higher result which was 45ml. We didn't do 30 minutes but we estimated that it should've been around 80 ml.

# data[].attributes.body
The water was dripping very slowly and it would sometimes stop occasionally. We would have to shake and move the cup whenever the water would stop dripping. For the first trial, the results for 15 minutes was 30mls.

# data[].attributes.body
We conclude that our results differ from one antother because in our second attempt we loosened the plastic cup. This could be the cause of why the water dripped faster than the first attempt.

# data[].attributes.body
1. We poked a small hole at the bottom of the plastic cup.

2. We placed the cup on the beaker and poured water inside the cup. (while you pour the water, start the 15 minutes timer.)

3. We waited for 15 minutes.

4. When the timer was done, we quickly took the plastic cup and we tipped out the extra water in the sink. Then we measured how many mls there was in 15 minutes.

5. Then we repeat it again.(2x)

# data[].attributes.body
Water, Plastic cup, Beaker, Timer and Pin

# data[].attributes.body
How much water drips into the cup in 15 minutes