# data[].attributes.body
for the fur i got a toothbrush, and eyebrow burs to try to make the fur

# data[].attributes.body
incomplete wall relief

# data[].attributes.body
For the cat head I didn't take pictures for the beginning process such as forming the head shape or how I made the dents for the mouth eye or eyebrows.  But in short what I basically did was get a little bit of clay, slipped it and put it the the cat head to create the lips and the nose for the cat.  The cat head was the first piece I made so it was more of a trial and error of how I can make the face shape. While adding the parts of the face that sticks out like the mouth and the nose i made small

# data[].attributes.body
For the paint brush I rolled out clay to the same thickness as a paint brush I had.  I flattened out one end of the brush so it can be the actual brush part of the paint brush. I then got a plastic hard to scrape of a little bit of clay to create the metal tip which holds the hairs to the brush handle.

# data[].attributes.attachment_link.keywords[]
Boats and boating--Equipment and supplies

# data[].attributes.body
For the cat paw i rolled out a thick piece of clay and then smushed it a bit so it can more of an appearance of a cat paw and arm. I then proceeded to cut slits out and mark where the separate toes are and hw big they should be. Then I cute a slit o each of the markings I made. To round out the slits for the toes I used a wet paint brush to smoothen them out and switched between the the brush itself and the end of the brush since my finger would be too big to work on the toes. For the "toe beans" or the pads that are at the bottom of the paw I rolled a small ball of clay and then slipped the part where the toe bean goes and then wet the outside of the ball. I then stuck the ball where I wanted it to be then smush it down and used the paint brushed to smoothen it.

# data[].attributes.body
For the cup I rolled out clay and then cut it to size then connected the side so it can make the actual cup. I then got the top of the cup to make it go inwards a bit and not be a straight cylinder. Then i cut it at an angle to make it 3D as if it's falling over and out of the wall relief.

# data[].attributes.attachment_link.keywords[]
Boats and boating--Equipment and supplies

# data[].attributes.body
Didn't take a picture of forming the actual head but here is the eye, nose, and mouth formed.