# data[].attributes.body
Didn't:
-  the photo paper wasn't scotched properly

Did:
- Still stayed up enough to take a few movement of the sun

# data[].attributes.body
- Scotch your sensitive paper for the paper not to fall

# data[].attributes.body
Slow shutter speed as you see the movement which gives an effect  of film version from natural lights.

# data[].attributes.body
It's an image which record moves of the sun's daily route over the sky. You usually capture this type of image with a pinhole camera. There is no needed to do any chemicals processes as the sun hits the paper and creates lines directly on paper. The solography does not need to get developed or fixed. You just have to scan the image, open it on Photoshop and invert the picture to obtain a positive picture. It is advised to fix the paper sensitive for it not to continue to develop.

# data[].attributes.body
Pinhole Camera

Inside
1.Take 1 hard board (A5 size)
2. With a pencil draw 2 diagonal lines to find the centre
3. Drill the hole
4. Place a strip of black aluminium foil over the holeand tape down on the inside of the box, and use a thin pin to poke a hole in the center of the foil from the outside of the box.
5. Leave a space on one piece of the paper to put a loose paper. The reason is to be able to open and close when wished while capturing the image.
6. Measure 5 side panels to have an equal square
7.Stick them on the  side with glue

Outside
8. Cut piece of paper and stick with gaffa tape on the 4 sides of the drill hole
9.Stick the sides of the box again above with gaffa type
10. Do the lid with any material you wish. The only condition is that no light must go through the sides.

Image

11. Put a sensitive paper in the box, opposite to the hole. The glossy part must be facing the hole. Make sure the hole is covered by a black paper.
12. Put the pinhole by a window.
13. Remove the piece of paper covering the hole.
14. Leave it exposed for a couple of months
15. Cover the hole back with the black piece of paper
16. Go in the Darkroom.
17. Remove the photo sensitive paper
18. Place it into the fixer

# data[].attributes.body
Pinhole Camera

1.Hard Board
2 Electric Drill hole
3  Pies of black paper to hide the hole
4. Glue for board
5. Gaffa type to hide holes

- photo sensitive
- fixer