# data[].attributes.body
On a beam bridge must of the support comes from the beams as they are sturdy enough to take all of the power.Distributing weight seems easiest on the arch bridge the arch is good support

# data[].attributes.body
I did pretty good with our team we did not do good but we tried.I think i led well because we all did different parts and we all worked.

# data[].attributes.body
What would we do differently if we had to do this again?Different type?I would make ours an arch type it would be long and have support so the pennies wouldn't fall over.The arch type

# data[].attributes.body
.Explain the parts of the model?Explain test results?The parts of our model wear the 3 beams at the bottom and the cover at the top.Our test results were horrible we got through 15 on the stacking and 20 on the length.

# data[].attributes.body
What were some difficulties?What were constraints?What was the criteria we had to meet?The difficulties were no tape to ground.The constraints were the size and the length.The criteria was 12 inches wide with no tape to ground

# data[].attributes.body
What were some of the things you guys thought of?We were going to use an arch bridge but then we went with the Straight bridge w/ beams

# data[].attributes.body
What is the Initial Problem? The Initial problem is us trying to build a bridge that will endure the strength of pennies.And get two ships by