# data[].attributes.attachment_caption
On this piece, I managed to get a pretty consistent wall thickness, however, it was much too thick to put in the kiln. I will need to work on getting the piece thinner while keeping the same consistency.  

# data[].attributes.attachment_caption
On this piece the symmetry was not awful, but I could still work on going up consistently at a slow pace so that the mass is evenly spread from the bottom to the top.

# data[].attributes.attachment_caption
On this piece, I had a pretty consistent thickness at a relatively good width, however at the bottom I have a lot of extra clay and at the top I pinched just slighty, making it thinner.

# data[].attributes.attachment_caption
For this piece, I completely messed up the symmetry by pulling up to fast which made one side of my piece taller than the other side.

# data[].attributes.attachment_caption
Although, on this piece, the wall collapsed after cutting it, the thickness was nearly perfect just slightly in consistent. Also there was too much clay sitting at the bottom.

# data[].attributes.attachment_caption
For this piece, you can tell that it had a lot of wobble as I didn't pull up constantly enough. To fix this I need to pull up slower which I have already been working on for my cylinder.

# data[].attributes.attachment_caption
For this double-bubble, My consistency on the thickness could have been better along with how thick each part was. Not bad for a first try on the double-bubble.

# data[].attributes.attachment_caption
The outside of this piece looks great but it was through the expense of the inside looking more inconsistent. There was rough symmetry that made this piece slightly better.

# data[].attributes.body
I have not achieved a perfect cylinder but I will work on it when I have a chance.

# data[].attributes.headline
Start of Vines (Ended up changing to multiple twisted lines)

# data[].attributes.subject
Start of Vines (Ended up changing to multiple twisted lines)