# data[].attributes.body
I started out by creating multiple tear-drop shaped petals by forming slabs and cutting out the shapes with a knife to form the petals for my flower.

# data[].attributes.body
I made 7 of these petals because that was the right amount to fit them all perfectly within the bowl I would use to create a slump bowl. I then slipped and scored them together indie the bowl.

# data[].attributes.body
This was when I was making sure all of the petals would fit in the bowl properly, and the next step after this, was the slip and score, which I did by removing each individual petal and adding slip.

# data[].attributes.body
After slip and scoring all of the pieces, I made sure to smooth out the bonds and cracks in between the petals to make it a smooth and continuous piece as a whole.

# data[].attributes.body
I then added 3 large petals and attached them to the base of the bowl to add depth to the bowl as a whole, and also because it would help create the foot of my bowl by lifting the base up slightly.

# data[].attributes.body
Afterwards, I added 3 smaller leaves to add more dimension to the piece, and fill in some blank gaps that I felt the bowl had.

# data[].attributes.body
The interior of the bowl felt pretty bare to me, so I carved out the details outlining the petal and center of the flower with a ribbon tool and needle tool.

# data[].attributes.body
I added a small lady bug to add a cute little detail and I will attach it after firing so that it is easier to glaze.