# data[].attributes.body
If you here weird sizzling sound. The wire speed needs to be adjusted

# data[].attributes.body
It sounds too fast or too slow.

# data[].attributes.body
If you go to fast the bead will become weak and thin making a sort of triangular peak.
If your weld speed is to slow your bead will create a tall and wide bead that’s not consistent.
If you have a good weld speed your bead will look like the ridges are a semi circle.

# data[].attributes.body
You can identify if you didn’t prep the material because it will make a weird sound if you don’t

# data[].attributes.body
If you travel To fast you can have some problems with the width of the weld/ fusion problems. If you go to fast you could over heat the metal. Pace yourself, pay attention.

# data[].attributes.body
Keep it a a 90 degree angle to get the best bead

# data[].attributes.body
You can identify if you don’t have good gas flow by looking at your weld. If your weld has porosity and containment’s it tells you don’t have gas. It’s also important to make sure the tank is open and your MIG tip is clean so the gas can flow properly.
Nick Hoppper

# data[].attributes.body
You should always keep the wire 1/4 inch sticking out from the tip of the gun

# data[].attributes.body
If the angle of your gun is to low or to high your weld will not be even.

# data[].attributes.body
If your puddle isn’t dropping into your metal and a weird bead

# data[].attributes.body
You can identify that your voltage is to high when there is a big pool of molten metal, or when the wire is melting into globs, you can tell if your voltage is to low if the wire is not fully melting.

# data[].attributes.body
Get your gun closer to 90 degrees/straight up and down.