# data[].attributes.body
Next time I would probably make the bridge thicker, and maybe not so wide or flimsy

I would add more support

Yes I feel like I worked hard and me and my partner equally shared the hard work

# data[].attributes.body
Our model was 1 1/2 paper length, with the sides folded up, the we had 3 tube-like supports going through the middle of the length of the bridge

The penny stack was to just stack up pennies and we did that in the middle where most of the support was, and the penny spread was we just spread pennies all over the bridge and it seemed one side was a lot stranger than the other

# data[].attributes.body
3. Plan
We went through a few difficulties, like when we were building, we kept messing up, and we thought we had an idea and every time we tried something it never worked

We tried avoiding running out of materials, but that really didn't work, and we also tried to avoid having something similar to what others have

Our criteria was to have 3 supports on a long beam bridge, with the sides kind of up, so nothing could fall out

# data[].attributes.body
2. Imagine
Some ideas we had were having 3 tube-like supports at the bottom, hoping it would stay up, also we decided to have on paper overlapping so it would reach the two paper stacks

Our bridge was a beam bridge, and we don't know why it is..we just built it and then decided what bridge it was and we saw it was as close to a beam bridge :)

# data[].attributes.body
Our problem was the bridge was too thin, and it was too wide, so it was very flimsy and pretty weak on the side because our supports where just in the middle...