# data[].attributes.body
Sludge is a mixture of plastics, powders and liquid wich you can do various test over the 3 days

# data[].attributes.body
the evaporating dish is used to heat thigs up that need to go to a temp higher than 110 degrees celcius. You are never allowed to put a thermometer on the evaporating dish

# data[].attributes.body
when you are mesureing liquid you are figuring the amount of water. Make sure you read to the line. always read in mL
ex: this is 10ML

# data[].attributes.body
when you are finding the mass of an object make sure you measure it in grams

# data[].attributes.body
1. Always wear goggles
2. dont forget boiling chips
3. try to use less liquid to work faster
4. Dont get hurt
5. dont worry your this far and you will suceed.

# data[].attributes.body
Boiling point is the temperature wich water starts to evaporate and turn into a gas.
---------------------------------------------
The steps for bp are as
following:
1. put on goggles
2. get all your supplies ready(Don't forget boiling chips)
3. heat up the liquid and take temperature every 30 seconds.
4.Once you have bubbles that is the bp
5. take 6 more readins of the plateau before you turn everything off

# data[].attributes.body
Micro melting point is when a solid turns into a liquid. In order to get this process you need to heat up the solid till it reaches its melting point.
If  a solid has a mp greater than 100 we have to find the mp using a evaporating dish without the thermometer..

# data[].attributes.body
to find density the formula is D=m/v and the density of the object can determine if a solid sinks or floats

# data[].attributes.body
phase changes are the stages when the object is going through a physical change either its is turning from a gas to a liquid or a liquid to a solid its is all phase changes

# data[].attributes.body
Intrinsic propert means that no matter how much you have of an object the vloume will stay the same. if you have 4 pounds of meat and 7 pounds of meat they are going to have the same volume beacsue they are the same objects.

# data[].attributes.body
Solubility is when you see if your liquid is soluble or not. the most common one is th sugar test and you check if your object is solube to sugar or in other words if sugar dissolves or not.

# data[].attributes.body
Fractional distillation is when you try to separate two liquids and try to make it pure. you use condensation to make a mixture pure.